MEASUREMENT TECHNOLOGY
Compressed air flow sensors
WRS is a manufacturer-independent company and works together with the best sensor manufacturers. We make sure that the sensors match your requirements. We will be happy to advise you on the right sensors for your individual requirements. All sensors are compatible with the AnalyzAir®.
- Installation under pressure is easily possible with the slide-in version
- A tapping clamp is used to drill a specific hole in the pipe and insert the sensor
- Chips do not get into the compressed air line thanks to a special tapping process
- Inlet and outlet routes must be observed
- Correct parameterization by a specialist is necessary
- Sensor technology is usually more cost-effective than the slide-in version
- Individual consumers or machines can be measured efficiently with it
- As the pipe is cut open, installation is only possible without pressure
- Inlet and outlet routes must be observed
- Correct parameterization by a specialist is necessary
- Installation under pressure possible
- Good accuracy classes, with correct parameterization
- Piping must be made of stainless steel or steel
- Plastic cables are not possible
- Inlet and outlet routes must be observed
- Correct parameterization by a specialist is necessary
Further sensors
- Installation is carried out via a quick coupling and is possible under pressure
- Monitoring the humidity in the compressed air system
- Prevent production downtimes through early alarms in the event of moisture in the system
- Conclusions on oil content, as this correlates with moisture
- Quick installation during operation
- The individual current phase is measured
- The power calculation assumes that the voltage and phase shift are constant
- Significantly cheaper than energy meters
- Precise localization of the leak
- Leakage assessment option
- Documentation for energy management
Get in touch with us
Discuss your requirements with an expert!
